Hach-Lange 2100 AN IS Laboratory Turbidimeter User Manual - Manual (Page 11)

Figure 3 Instrument components
1 2100AN IS turbidimeter 6 Gelex ® secondary turbidity
standardization kit 1
2 Oiling cloth 7 Dust cover
3 Six 1" sample cells (30 mL) with
caps
8 Printer paper roll (2x) 2
4 Silicone oil 9 Power cord
5 StablCal ® Calibration kit
1 Supplied with 4790100 only.
2 Do not remove the plastic wrapper from the paper rolls until the paper is
installed.
Installation
D A N G E R
Multiple hazards. Only qualified personnel must conduct the tasks
described in this section of the document.
Put paper in the printer
N O T I C E
Use only the provided thermal paper. Use of other thermal paper may cause poor
print quality and decrease the life of the print-head.
Notes:
• Do not rub the thermal paper with a hard object.
• Do not use chemical paste on thermal paper.
• A red line on the edge of the thermal paper shows when the paper
supply is low.
1. Cut the end of the paper with scissors to make an arrow shape.
2. Open the printer cover.
3. Put the point of the thermal paper in the paper entrance slot.
4. Push the paper through until the point of the paper comes out the
exit slot.
5. Pull the paper out of the exit slot until the full width of the paper is
past the exit slot.
6. Put the paper roll in the printer.
7. Put the thermal paper through the slot in the printer cover, then close
the printer cover.
English 9