Change led brightness, Error blink, Beep on button press – INSTEON SwitchLinc Relay (Dual-Band) (2477S) Manual User Manual
Page 12: Blink on traffic, Factory reset, Phase detect beacon, Changing led brightness, Error blinking, Air gap (removing power)
Page 12 of 18
2477S - Rev: 1/21/2014 7:27 AM
Change LED Brightness
Configure using home automation software (such as HouseLinc) or follow the steps below to change the
brightness level of SwitchLinc’s LED.
1) Press and hold SwitchLinc Set button until it beeps.
LED will start blinking
green
.
2) Press and hold Set button until it beeps again.
SwitchLinc LED will start blinking
red
.
3) Press and hold Set button until it beeps a third time.
SwitchLinc LED will stop blinking and turn off.
SwitchLinc LED will illuminate at current LED brightness level.
4) Use SwitchLinc paddle to adjust LED brightness:
-
Press and hold paddle top to brighten.
-
Press and hold paddle bottom to dim (fully off for dimmest).
5) Once you have reached the desired brightness for the LED, tap Set button.
SwitchLinc LED will remain at new desired brightness.
SwitchLinc will double-beep.
Error Blink
This setting is only adjustable via software (such as HouseLinc). SwitchLinc LED will blink
red
for a few
seconds if one or more responders do not acknowledge a message.
Beep on Button Press
Default = off.
This setting is adjustable via software or a central controller only.
Blink on Traffic
This setting is only adjustable via software (such as HouseLinc). SwitchLinc LED will blink
red
to indicate
noise on the powerline.
Factory Reset
Factory Reset clears all user settings from SwitchLinc including INSTEON scenes, X10 addresses, etc.
1) Pull out Set button to create an air gap See Air Gap (Removing Power).
2) Wait 10 seconds.
3) Press and hold the Set button.
SwitchLinc will begin to emit a long beep.
4) Don’t release Set button until beeping stops.
5) Release Set button.
After a few seconds, SwitchLinc will double-beep.
The load/light(s) will turn on.
LED will return to default brightness.
Phase Detect Beacon
SwitchLinc On/Off Switch Dual-Band automatically detects the electrical phases in your home (via
communications with other dual-band devices on the other phase). This is only important if you have
powerline-only products in a building with multiple phases (split-single or 3-phase).