INSTEON KeypadLinc Relay (2487S) Manual - Manual (Page 5)

Page 5 of 25 2487S - Rev: 1/21/2014 7:37 AM
Optional Accessories
Accessories Link
Custom Etched and Pre-
Printed Buttons
http://www.smarthome.com/_/KeypadLinc/KeypadLinc_Custom_Buttons
/_/2vj/2wf/nav.aspx
Color and 6/8 Button
Change Kits (15)
http://www.smarthome.com/_/KeypadLinc/KeypadLinc_Change_Kits/_/2
vj/2wb/nav.aspx
Blank Buttons
http://www.smarthome.com/2401BT10/Blank-10-Button-Set-for-
KeypadLinc-White/p.aspx
Clear Buttons
http://www.smarthome.com/2401CLB/6-or-8-Button-Change-Kit-for-
KeypadLinc-Clear/p.aspx
LED Color Change Kit
http://www.smarthome.com/2401L/LED-Color-Change-Kit-for-
KeypadLinc-4-Color/p.aspx
Helpful Videos
- Linking to a KeypadLinc
- Unlinking from a KeypadLinc
- Changing out the KeypadLinc Buttons
- Adding LED Diffusers to the KeypadLinc
Installation
CAUTIONS AND WARNINGS
Read and understand these instructions before installing and retain them for future reference.
KeypadLinc is intended for installation in accordance with the National Electric Code and local regulations in the United States or the
Canadian Electrical Code and local regulations in Canada. Use indoors only. KeypadLinc is not designed nor approved for use on
power lines other than 120VAC or 277VAC 60Hz, single phase. Attempting to use KeypadLinc on non-approved power lines may
have hazardous consequences.
• Use only indoors or in an outdoor rated box
•
Be sure that you have turned off the circuit breaker or removed the fuse for the circuit you are installing KeypadLinc in.
Installing KeypadLinc with the power on will expose you to dangerous voltages.
•
Connect only copper or copper-clad wire to KeypadLinc
• KeypadLinc may feel warm during operation. The amount of heat generated is within approved limits and poses no
hazards. To minimize heat buildup, ensure that the area surrounding the rear of KeypadLinc is as clear of clutter as
possible.
• Each KeypadLinc is assigned a unique INSTEON ID, which is printed on the device’s label.
•
To reduce the risk of overheating and possible damage to other equipment, use KeypadLinc to control no more than 20
Amps (1800 Watts of incandescent) at 110VAC or 277VAC.
•
You will need a flathead screwdriver, a Philips head screwdriver and a voltage meter to install KeypadLinc
Identifying the Electrical Wires in your Home
To install KeypadLinc, you will need to identify the following four wires:
• LINE - usually black, may also be called HOT or LIVE, carries electricity into the outlet