INSTEON Outdoor On/Off Module (Dual-Band) (2634-222) Manual - Manual (Page 5)

Page 5 of 13 2634-222 - Rev: 1/21/2014 7:45 AM
Using On/Off Outdoor Module
Local Control Operation
LED Activity
Adjust Local Settings
LED On or Off
Default = On
This setting is only adjustable via software or a central controller. When enabled, LED On will cause the LED to be
green when the Load is on and Red when the load is off.
Blink on Traffic
Default = enabled
This setting is only adjustable via software or a central controller. On/Off Outdoor Module LED will blink green for
INSTEON traffic and if it detects noise that could disrupt communication.
Programming Lock
Default = disabled
This setting is only adjustable via software or a central controller. When enabled, Programming Lock will disable the
set button so that a user can not adjust settings or modify links. This is typically used in commercial or installer
applications.
Connected load/responders
Tap Double-tap LED
Set Button
On/Off On/Off
(instant)
Green/
Red
LED Status/Setup Mode
Solid green Load is on
Solid red Load is off
Blinking green Linking mode
Blinking red Unlinking mode