INSTEON Thermostat with Humidity (2441TH) Manual - Manual (Page 16)

Page 16 of 28 Rev: 1/21/2014 8:35 AM
Removing INSTEON Thermostat as an INSTEON Controller
If you want to remove INSTEON Thermostat from a scene as a controller, follow instructions below.
Whenever possible, use software for managing scene memberships.
Note: If you choose to remove INSTEON Thermostat from use, it is important that you remove scene
memberships from all responders. Follow the instructions below for each responder of which INSTEON
Thermostat is a member.
1) Press and hold INSTEON Thermostat’s Set button until it beeps.
INSTEON Thermostat Set LED will blink green .
INSTEON Thermostat will beep.
2) Press and hold INSTEON Thermostat’s Set button again to put it in scene mode.
INSTEON Thermostat Set LED will blink red .
INSTEON Thermostat will beep.
LCD display indicates the group from which you are removing the scene.
3) Tap Up and Down arrows to select appropriate group to remove from:
• Group 1 - Cooling mode change, default
• Group 2 - Heating mode change
• Group 3 - Dehumidifiation, high humidity setpoint
• Group 4 - Humidification, low humidity setpoint
4) Press and hold responder’s Set button.
INSTEON Thermostat will double-beep upon completion.
LED will return to previous state.
Upon entering Add to a Scene mode.
Upon entering Remove from a Scene mode (defaults to Cooling mode).