INSTEON Energy Display (2448A2) Quick Start - Manual

Page 1 of 2
Rev. 7/28/2011 4:42 PM / See Owners Manual for Warranty Information, Patented
© Copyright 2011, Smarthome, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Display
options
Battery level
Quick-Start Guide
Energy Display – INSTEON ® In-Home Display
Model: 2448A2
Introduction
Energy Display reads power consumption information from
INSTEON meter devices such as iMeter Solo (#2423A1). Also
displays current power use, average energy use per month, and
average cost per-month based on your monthly billing rate.
Status
LED
Set button
Restart/Up
button
Mode
button
1-2-3/Down
button
Refresh
button
Installation
Be sure you have properly installed at least one dual-band
INSTEON device and an INSTEON meter device.
1) Remove the battery compartment and install the two AAA
batteries (included), and then replace the cover
The Energy Display screen will turn on all LCD segments.
After a few seconds, the screen will go to Display Mode.
Linking to an INSTEON Meter Device
1) Be sure the device you wish to monitor is on and connected to a
INSTEON meter device
2) Tap the 1
-
2
-
3/Down button until Meter 1 position is blinking
(use Meter 2 and 3 for subsequent meters)
3) Set Energy Display to Linking Mode* by pressing & holding the
Energy Display Set button until it beeps (3 seconds)
The Energy Display Status LED will begin blinking GREEN
4) On the meter device, press & hold the Set button until it beeps
(3 seconds)
Energy Display will double-beep and its Status LED will
turn off. A few moments later the Energy Display will show
information for the device you are metering.
*Setup Modes will automatically time out after 4 minutes.
Meter 1 Meter 3 Meter 2
Temperature Cost
setting
Using Energy Display – Display Mode
Data is retrieved when:
 Energy Display is first Linked to a meter device
 Refresh button is tapped while Energy Display is in Display Mode
 Any button is tapped in Standby Mode
Power-related information will display for one minute before Energy Display enters Standby Mode. In Standby Mode, only the battery
level and temperature will display. Tap any button to exit Standby Mode and return to Display Mode.
Button Action
 Tap to cycle between display setting options:
 Instantaneous Watts used (Now | W)
 Average cost per month (Avg | $/mo)
 Average energy used per month (Avg | kWh/mo)
 Press & hold until the cost setting field begins blinking to enter Setup Mode.
Press & hold for until it beeps (10 seconds) to reset the energy value for the currently displayed meter
(for calculating average energy used and cost/month)
Tap to cycle between each meter device to be displayed (Meter 1, 2, or 3)
The Energy Display will display information about your meter device after a few seconds.
Tap to read current information for all meter devices