Configuring energy display – setup modes, Owner’s manual & tech support – INSTEON Energy Display (2448A2) Quick Start User Manual
Page 2
Page 2 of 2
Rev. 7/28/2011 4:42 PM / See Owners Manual for Warranty Information, Patented
© Copyright 2011, Smarthome, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Configuring Energy Display – Setup Modes
Button Action
To enter Setup Mode, press & hold the Mode/Setup button until the cost setting field begins blinking.
Then tap the Mode/Setup button to cycle to the desired settings.
Cost Setting
Range is 0.1 to 999 cents/kWhr ($9.99/kWhr). Once the counter reaches 999 cents, it will reset to 0.1 cents. The default is 10 cents.
Button Action
Tap up to increase or down to decrease the cost.
If cost is less than 100 cents, cost will change by 0.1 cents.
If cost is greater than 100 cents, cost will change by 1 cent.
Press & hold to continuously increase or decrease cost.
Tap to accept current Cost setting and exit Setup Mode
Temperature Format Setting
Format toggles between Celsius and Fahrenheit. The default is Fahrenheit.
Button Action
Tap to toggle the temperature display between Celsius and
Fahrenheit
Tap to accept current Temperature Format setting and exit Setup
Mode
Temperature Calibration Mode
The Energy Display temperature comes pre-calibrated. Only perform these steps if re-calibration is necessary. Please allow 20
minutes for temperature to adjust when moving to an area with a significant temperature change.
Button Action
Tap to set local temperature (based on a thermostat or other
device)
Note: Place Energy Display close to your temperature reference
device (e.g., thermostat or thermometer) for approximately 20
minutes to ensure it is settled to a stable temperature.
Tap to accept current local temperature
Owner’s Manual & Tech Support
Owner’s Manual:
For the most up-to-date Quic
INSTEON Gold Support Line: 800-762-7845