INTELLINET NETWORK IDC-862 Hardware Installation Guide - Manual (Page 4)

I/O Terminal Block
The Intellinet Network Camera provides an external I/O terminal block
which is used to connect input / output devices such as alarms or sensors.
The pin definitions are described below
PIN Definition Description Max. V/A
1 Ground -
2 + 5V DC
5V DC
0.5W
3 AUDIO_In(+) Unbalanced, 1.4Vp-p, 1Vrms, terminal block -
4 AUDIO_In(+) Unbalanced, 1.4Vp-p, 1Vrms, terminal block -
5
Digital Output
1
Uses an NPN transistor with the emitter connected to
the GND pin. If used with an external relay, a diode
must be connected in parallel with the load for
protection against voltage transients.
100 mA
24V
7 Digital Input 1
Connected to GND to activate, or leave floating (or
unconnected) to deactivate.
30V DC