intimus 502 - Manual (Page 4)

SCOPE OF APPLICATION:
The document shredder
INTIMUS 502MHS is a
machine for the destruction of common written
material.
The machine may only be used to
shred paper!
Shredding of other types of data carriers
and of staples and paper clips may lead
to injuries (for example due to splintering
of hard materials etc.) and damage to
the machine (for example destruction of
the cutter etc.).
INSTALLATION:
- Unpack and set machine upright.
- Place plastic sack into the receptacle.
- Plug in the machine (for instructions for the
necessary precautions see „TECHNICAL
DATA“.
The air vents in the housing are ne-
cessary for cooling and may not be
covered or closed!
The mains connection at the machine
must be freely accessible!
Only operate the machine in enclosed
rooms at temperatures between 10°C
and 25°C!
CONTROLS:
1 = Pushbutton switch „forward“ (fig. 1)
Depress this switch to start the machine or
to stop the machine.
2 = Pushbutton switch „reverse“ (fig. 1)
Pressing this button activates the cutting
mechanism into reverse.
3 = Pilot lamp „forward operation“ (fig. 1)
Lights when the pushbutton switch (1) is
operated. The cutting system runs forward.
4 = Pilot lamp
„receptacle full“ / „door open“ (fig. 1)
Lights when
a) the receptacle is full and needs to be
emptied. At the same time the machine
switches off automatically.
b) the door is not closed. The machine then
switches off automatically and it cannot be
started as long as the door is open.
5 = Pilot lamp „paper jam“ (fig. 1)
Lights when too much paper is fed to the
cutters. The cutting system blocks and stops.
The motor is switched off.
FEEDING THE PAPER:
- Turn machine on with pushbutton switch (1)
(fig. 1). The cutting system runs forward. Pilot
lamp lights up (3) (fig. 1).
- Feed paper through the inlet guide to the cutting
system.
- After shredding turn machine off with pushbutton
switch (1) (fig. 1).
Never feed the shredder with a quantity
of paper exceeding the maximum indi-
cated in the technical details.
Should the machine be overfed, follow the
instructions under „PAPER JAM“.
EMPTYING THE RECEPTACLE (Fig. 2):
When the receptacle is full, the machine turns off
automatically. The pilot lamp (4) (fig. 1) lights up.
Empty the receptacle as follows:
- Open door. Remove the full sack and dispose
of contents.
- PLace empty sack into receptacle and close
door.
Note: The machine will only run with closed
door!
<< The machine may not be operated by more
than one person at any given time!
The machine was designed for safe operation
by “one person only”.
<< During the shredding process no other
work may be performed on the machine
(for example cleaning, etc.)!
<< The machine is not a toy, and is not suitable
for use by children!
The overall technical safety concept of
this machine (dimensions, feed openings,
emergency shutdown devices etc.) does not
provide for any guarantee regarding hazard-
free operation by children.
<< Danger of injury! Keep all
loose articles of clothing, ties,
jewelery, long hair or other loose
objects away from opening!
<< Danger of injury! Never insert fingers into
opening!
<< In case of danger switch the machine off
with the mains switch, or with the emer-
gency switch, or unplug the machine!
<< Always unplug the machine from the
mains power supply before opening the
machine!
Repairs may only be performed by trained
personnel!
IMPORTANT SAFETY NOTES
4
INITIATION
OPERATION
GB
fig. 2 fig. 1
3 4 1
5 2
502MHS