intimus 502 - Manual (Page 5)

5
MALFUNCTIONS
COMPENSATION OF THE CONTROL PCB:
In order to eliminate malfunctions in the electronic
control it is possible to carry out a manual com-
pensation of the control PCB. The procedure is
as follows:
1. Switch off the maschine at the pushbutton
switch (1) and open the door.
2. Press the pushbutton switch „reverse“ (2) and
keep it pressed.
3. Press the „forward“ pushbutton switch (1).
4. Release the „reverse“ pushbutton switch (2)
after approx. 3 sec.
6. Close the door. The cutting system runs for-
ward.
The compensation of the control PCB is com-
pleted.
PAPER JAM:
If too much paper is fed to the cutting system the
machine will react as follows:
- The cutting system blocks, reverses a bit to
release the paper and then stops.
- The motor shuts down automatically.
- The pilot lamp (5) (fig. 1) lights up.
Proceed as follows:
- Briefly operate the pushbutton switch for reverse
(2) (fig. 1).
- The pilot lamp (5) (fig. 1) goes off.
- Remove excess paper from the machine and
continue shredding with less paper.
MOTOR PROTECTION:
The motor shuts down automatically, should it
become overloaded. Turn the machine off with
the pushbutton switch (1) (fig. 1).
Allow the motor to cool down for 15 to 20 minutes
(depending upon room temperature) and then
continue shredding.
CHECKLIST IN CASE OF MALFUNCTIONS:
If the device does not function, check the follo-
wing:
- Is the
plug connected to the mains?
Mains connection: 2-pole mains switch,
internal appliance plug,
separate power cord
- Is the pushbutton switch (1) on?
- Is the door closed?
- Is the receptacle full?
The receptacle has to be emptied.
- Is there a
paper jam?
Follow the instructions under „paper jam“.
- has the
motor been overloaded?
Wait until the motor has cooled, and then re-
start.
If none of the above applies, please contact
your dealer.
MAINTENANCE TECHNICAL DATA
Cutting width: 0.8x12 mm
(high security)
Cutting capacity: 8-10 sheets (70g/m 2 )
Supply voltage: 230V/50Hz
240V/50Hz
120V/60Hz
100V/50/60Hz
Pre-fusing: 10 amps (slow-blow)
Working width: 260 mm
Noise level: approx. 54 dB(A)
Power: 1.1 kW
Dimensions:
Width:
490 mm
Depth: 380 mm
Height: 870 mm
Weight: approx. 43 kg
ACCESSORIES
Description Order-No.
Plastic bag, 440 x 330 x 950 x 0,05 mm 99977
Lubricant, 125 ml bottle 99943
Note: For orders of special accessories and spare parts, please contact your dealer.
GB
502MHS
DISPOSING OF THE MACHINE:
Dispose of the machine in an
environmentally sound fashion at the
end of its useful service life. Do not
dispose of any of the parts included
in the machine or its packaging with
household trash.
DISPOSING
MAINTENANCE:
After approximately 30 minutes of con-
tinuous use, run the cutting system in
reverse for 15 to 20 seconds and spray
some of the enclosed Special Oil onto the
cutting system.