King Technology SPA FROG In-Line System - Manual (Page 4)

4
START UP • Follow all directions from
your spa manufacturer on filling and
balancing the water in your spa.
• Use a metal out or sequestering agent if
fill water is high in metals. Wait 24 hours
before continuing start up.
• Very Important! Before using cartridges,
establish an initial residual of 1.0-2.0 ppm
bromine or chlorine. Do not use a non-chlorine shock.
Do NOT add through the SPA FROG In-Line System.
For best results use FROG Jump Start that quickly dis-
solves with an effervescent fizzing action – one packet
per 500 gallons.
• Use FROG Brand Test Strips to accurately maintain the
reduced 1.0 to 2.0 ppm bromine level following the
label directions carefully.
• When spa reaches operating temperature per your
spa manufacturer’s directions, set the mineral and
bromine cartridges according to directions on page 6
and insert them into the System.
REPLACING CARTRIDGES
• Open cap of SPA FROG In-Line System and set aside.
DO NOT OPEN CAP WHILE JETS ARE ON.
• Remove holder by pushing down and turning
counterclockwise before pulling out.
• Remove spent cartridges by pushing bottom out
through openings in back of holder. Then grab
cartridge and pull out.
W
ATER
B
ALANCE
G
UIDELINES
pH: 7.2-7.8
Total Alkalinity: 80-180 ppm
Calcium Hardness: 150-400
Total Dissolved Solids: <1500
*Free Bromine: 1.0-2.0 ppm
*NOTE: Bromine levels are lower only
when used with FROG minerals.
¨
B R A N D
®
B R A N D