King Technology SPA FROG In-Line System - Manual (Page 6)

6
Adjusting and Replacing SPA FROG Bromine Cartridge:
As every spa is different, finding the right setting for the bromine cartridge will
require monitoring your usage for the first week or two. Begin with an initial
setting based on the chart on page 7 and monitor bromine levels daily or
before each use, adjusting the cartridge by one setting per day until a 1.0-2.0
ppm level has been achieved. Use FROG Brand Test Strips with the ideal FROG
bromine range clearly marked on the label. To adjust cartridge, remove from
system and turn to the next highest setting if the bromine level is low, or the
next lower setting if the bromine level is high. The bromine cartridge needs to
be replaced when empty. Drain water to ensure empty then discard in trash.
On most spas, it will last between 2 – 4 weeks. Always maintain at least 1.0
ppm bromine level.
Adjusting and Replacing SPA FROG
Mineral Cartridge:
Set SPA FROG Mineral Cartridge
wide open on #6 by holding the bottom and turning the
top until the number 6 appears in the setting window.
The SPA FROG Mineral Cartridge must be replaced
every 4 months. After four months of use, or when
draining and refilling the spa with fresh water, discard
SPA FROG Mineral Cartridge in trash even if, upon shaking, it appears there
is spent media left inside. Once wetted the time released minerals in the
cartridge are effective up to four months. Do not attempt to reuse the
product once removed from the spa. For ease in remembering, mark your
calendar with the Reminder Stickers included with this manual. (See spa
manufacturer’s draining recommendations.)
BR A N D
NOTE: The more you use the spa, for instance when you first get it, the greater
the setting to achieve at least 1.0 ppm. (This may require a higher setting than
what is listed in the chart.) If usage decreases or the bromine level is greater than
2.0 ppm, the setting should be lowered.