King Technology POOL FROG Twin - Manual (Page 12)

12
1.
2.
3.
4.
5.
1.
2.
3.
POOL FROG TWIN™ Cycler Maintenance
Replacing the Control Dial O-Rings
In the back of the POOL FROG
TWIN™ Cycler depress center
of locking pin with a finger and
pull pin out of dial.
Center of locking pin
Turn control dial back and
forth as you pull it out of the
housing.
Replace both o-rings. Apply
silicone lubricant that came
with your POOL FROG TWIN™
Cycler on o-rings.
Carefully insert control dial
back into housing.
Replace locking pin by pushing
it through the slots on the dial
until it locks into place.
Replacing Cap O-Ring
Lubricate o-ring often with
silicone lubricant that
came with your POOL FROG
TWIN™ Cycler. DO NOT USE
petroleum based lubricants.
Replacing Knobs
To replace, simply unscrew old
knob and replace with the new
one.
Front of Cyclers Back of Cyclers
Hold cap in front of you
upside down with the o-ring
groove facing up. Place one
end of o-ring into cap groove
at the point closest to you.
Hold o-ring down with the
thumb and index finger of
one hand.
Take hold of the far end of
the o-ring with the thumb
and index finger of the other
hand. Roll o-ring slightly
back towards you as you
stretch the o-ring into the
remainder of the cap groove.
12