Replacing the mineral reservoir, Replacing a pool frog® mineral reservoir – King Technology POOL FROG Twin User Manual

Page 7

Advertising
background image

7

Replacing a POOL FROG® Mineral Reservoir

(POOL FROG® Mineral Reservoirs MUST be Replaced Every Season)

1.

2.

3.

4.

5.

6.

Check the top of the box and back label of product to make
sure you have the correct POOL FROG® Mineral Reservoir to
fit your POOL FROG Mineral Cycler.

THE POOL FROG® MINERAL RESERVOIR MUST BE REPLACED
EVERY 6 MONTHS OR AFTER ONE POOL SEASON
WHICHEVER IS SHORTER.

IMPORTANT: Remove and read the
information card.

Please note: Complete instructions
for inserting a POOL FROG® Mineral
Reservoir, FROG BAM® and POOL
FROG® Pac are included inside the
POOL FROG® Mineral Reservoir box.

WARNING

USE ONLY the factory recommended replacement
POOL FROG® Mineral Reservoir, FROG BAM® and
POOL FROG® Pac. DO NOT USE any other pac or bulk
chemical tablets in the POOL FROG TWIN™ Cyclers.
Use of any other product could result in damage to
pool equipment or surface, unsafe pool conditions,
fire or explosion. Warranty will be void if the correct
POOL FROG® Mineral Reservoir, FROG BAM® and
POOL FROG® Pac are not used.

Turn off pump and turn dial to
OFF. This reduces the flow of
water into the unit when the
cap is open.

Open cap of the POOL
FROG® Mineral Cycler.

Find slot on side of
POOL FROG® Mineral
Reservoir and line
up with fin inside
the POOL FROG®
Mineral Cycler. Lower
POOL FROG® Mineral
Reservoir into POOL
FROG® Mineral Cycler
until secure.

Advertising