King Technology POOL FROG Model 6100 - Manual (Page 12)

12
POOL FROG
®
Cycler Maintenance
SILICONE
LUBRICANT
Replacing Cap O-Ring
Replacing Knobs
COPY
COPY
COPY
COPY
xxxxx
SLICONE
LUBRICANT
Back of
POOL
FROG ®
Cycler
Front of
POOL
FROG ®
Cycler
1.
2.
3.
4.
5.
1.
2.
3.
®
®
Replacing the Control Dial O-Rings
Center of locking pin
In the back of the POOL
FROG® Cycler depress center
of locking pin with a finger and
pull pin out of dial.
Turn control dial back and
forth as you pull it out of the
housing.
Replace both o-rings. Apply
silicone lubricant that came
with your POOL FROG® Cycler
on o-rings.
Carefully insert control dial
back into housing.
Replace locking pin by pushing
it through the slots on the dial
until it locks into place.
Hold cap in front of you
upside down with the o-ring
groove facing up. Place
one end of o-ring into cap
groove at the point closest
to you. Hold o-ring down
with the thumb and index
finger of one hand.
Take hold of the far end of
the o-ring with the thumb
and index finger of the
other hand. Roll o-ring
slightly back towards you
as you stretch the o-ring
into the remainder of the
cap groove.
Lubricate o-ring often with
silicone lubricant that
came with your POOL
FROG® Cycler. DO NOT
USE petroleum based
lubricants.
To replace, simply unscrew
old knob and replace with
the new one.