King Technology POOL FROG Model 5400/5430 - Manual (Page 16)

16
4 0 0 S E R I E S
W a t e r
C Y C L E R
M e t e r e d P
o o l P u r i f i e r
4 0 0 S E R I E S
W a t e r
C Y C L E R
M e t e r e d P
o o l P u r i f i e r
4 0 0 S E R I E S
W a t e r
C Y C L E R
M e t e r e d P
o o l P u r i f i e r
W a t e r
C Y C L E R
M e t e r e d P
o o l P u r i f i e r
2” – 36” apart on straight pipe
SCOOPS 2”– 36”
APART ON STRAIGHT
PIPE
Screw elbow into reducer
bushings on both sides.
Attach a gasket to
each scoop.
Tighten scoop clamps with a
screwdriver.
Cut tubing
to size for
each POOL
FROG® Cycler
connection
and attach one
to each elbow
with clamps.
Place scoops inside
holes so the inlet
scoop faces the
water flow and the
outlet scoop faces
away from the water
flow. Scoop arrows
should be facing
each other when
correct.
Attach each hose to
venturi scoop male
nipple with a small
clamp and tighten
with screwdriver.
Tighten clamps
with screwdriver.
When pipe is
totally dry, drill
two 19/32”
or 5/8” holes,
between 2” - 36”
apart, on the
return line. Be
careful not to go
through other
side of pipe.
Arrows on scoops must
face each other.
For best results use Phillips
pan head screws through the
mounting holes at the POOL
FROG® Cycler base to secure
the POOL FROG® Cycler into
a treated wood base.
If using the POOL FROG® Bac Pac, isolating the POOL FROG®
Cycler by installing a corrosion resistant check valve is
recommended.
6. 7. 8. 9.
10. 11. 12.
13. 14. 15.
16.
Attach scoop clamps over the
scoops and around the pipe.