King Technology POOL FROG Mineral Hybrid System Analog - Manual (Page 7)

Inserting POOL FROG ® Mineral Reservoir
( POOL FROG ® Mineral Reservoirs MUST be Replaced Every Season)
SLOT IN POOL
FROG
®
MINERAL
RESERVOIR
FIN INSIDE
OF POOL
FROG
®
CYCLER
IN GROUND SERIES 5400 (Order #01-12-5462)
NOW FITS THE FOLLOWING CYCLERS:
POOL FROG Series 5400 or 5600
Prevail Series 5790
7 0 22906 05461
4.
5.
3.
6.
2.
7.
8.
7
• Find slot on side of
POOL FROG ® Mineral
Reservoir and line up
with fin inside the
POOL FROG
® Mineral
Hybrid Cycler. Lower
POOL FROG
® Mineral
Reservoir into POOL
FROG
® Mineral Hybrid
Cycler until secure.
• Turn off pump.Turn dial to
0. This reduces the flow of
water into the unit when the
cap is open.
• Use the cap tool included
with POOL FROG ® Mineral
Hybrid Cycler to loosen cap
by hitting the handle with the
flat of your hand counter
clockwise.
Open the box and remove the POOL FROG ® Mineral
Reservoir.
• Turn control dial on POOL
FROG ® Mineral Hybrid
Cycler to Maximum.
• Replace cap by hand only.
DO NOT OVER TIGHTEN.
1.
CAUTION read carefully
• USE ONLY the factory recommended replacement POOL
FROG ® Mineral Reservoir or POOL FROG ® Bac Pac if
needed. DO NOT USE any other pac or bulk chemical
tablets in the POOL FROG
® Mineral Hybrid Cycler. Use of
any other product could result in damage to pool equipment
or surface, unsafe pool conditions, fire or explosion.
Warranty will be void if the correct POOL FROG
® Mineral
Reservoir is not used.
• Check the front of the box and back label of product to
make sure you have the correct POOL FROG ® Mineral
Reservoir to fit your POOL FROG ® Mineral Hybrid Cycler.
THE POOL FROG ®
MINERAL RESERVOIR MUST BE
REPLACED EVERY 6 MONTHS OR AFTER ONE POOL
SEASON WHICHEVER IS SHORTER.
When salt is dissolved and the Output Level reads #7
which means the salt requirement has been met (see
directions on side of control panel), insert POOL FROG
®
Mineral Reservoir into POOL FROG ® Mineral Hybrid Cycler
following these directions.