CognitiveTPG A776 - Manual (Page 11)

10 11 10 11
Margin Messages
1. Margin Message spacing – There are two ways that you can change the print spacing of the Margin Messages on your
receipt: “Distance from start of print data to Margin Message” and “Distance between consecutive margin messages
in mm.”
a. “Distance from start of print data to Margin Message” – This parameter can be changed to adjust where the
Margin Message will be printed relative to the start of the print data. The default setting for this parameter is 1 dot
rows or about 0.0” (0.13 mm) from the start of the print data. Increase this
value if you want the Margin Message to print further from the start of the
print data, or decrease it if you want to make the distance shorter. The range
for this parameter is 1 to 255 dot rows.
b. “Distance between consecutive margin messages in mm” – This option
allows you to alter the spacing between Margin Messages. The default
setting for this parameter is 7 dot rows or about 0.04” (1.0 mm) between
printed Margin Messages. Increase this value if you want to open the
distance, or decrease the value if you want to close it. The range for this
parameter is 1 to 255 dot rows. Depending on the Toggle Mode, the
separation may be between a Margin Message in the left margin and the
next one in the right margin.
c. To apply your changes, click on the Apply button located on the bottom right-hand side of the screen.
d. If you wish to restore either of these parameters to their original values, simply click on the Defaults button located
in the middle of the screen.
2. Margin message toggle mode – This option, which is located on the bottom left-hand side of the screen allows you
to choose the margin(s) on which the Margin Messages will be printed. The alternating mode is the default parameter.
There are four possible choices:
Both Sides – The Margin Messages print at the same time in both margins.
Alternating – The Margin Messages print in an alternating fashion between right and left margins.
Right Margin Only – The Margin Messages print only in the right margin.
Left Margin Only – The Margin Messages print only in the left margin.
a. To apply your changes, click on the Apply button located on the bottom right-hand side of the screen.
b. If you wish to restore either of these parameters to their original values, click on the Defaults button located in the
middle of the screen.