Audiovox NAV3000 - Manual (Page 38)

SDVC Mode
(Speed Dependent Volume Control)
This is to compensate the surrounding noise by increasing the volume level of
guidance advice depending on the vehicle’s speed.
You can select between 5 different SDVC settings (OFF = off; 4 = maximum increase).
☞
Move the cursor to the Mode value.
☞
Push the OK key.
☞
Select the desired SDVC mode.
☞
Push the OK key to store the selection.
Find a suitable compensation by trying out the different modes.
System information
The “
System information” menu shows you information on soft- and hardware
versions of the system (for service purposes).
Service
For analysing hardware and software problems (code protected).
The “Service” menu should only be entered for service of the Navigation System by an
authorized service center.
Trip Computer
☞
Select the “
Trip computer” option from the “System settings” menu.
You can perform the following settings within the trip computer menu:
Speed limit:
☞
Move the cursor on the value next to “
Limit:”.
☞
Push the OK key.
☞
Select the desired speed setting with the cursor keys
4 or 6.
☞
Push the OK key to confirm the selection.
Enable/disable speed warning:
☞
Move the cursor on the option next to “
Speed warning:”.
☞
Push the OK key.
☞
Select “
On” or “Off”.
☞
Push the OK key to confirm the selection.
If you have enabled the speed warning, a warning beep is heard and a warning
message appears on the display each time you exceed the value stored under “Limit”.
Resetting the trip computer:
☞
Move the cursor on “
Reset Trip comp”.
☞
Push the OK key.
:
All values (except the speed limit) are set to zero.
SYSTEM SETTINGS
38