CTEK MXS 5.0 CHECK - Manual (Page 6)

8 • EN
TECHNICAL SPECIFICATIONS
Charger model MXS 5.0 CHECK
Model number 1066
Rated Voltage AC 220–240VAC, 50–60Hz
Charging voltage 14.4V, 14.7V, 15.8V
Min battery voltage 2.0V
Charging current
5A max
Current, mains 0.65A rms (at full charging current)
Back current drain* <1Ah/month
Ripple** <4%
Ambient
temperature
-20°C to +50°C, output power is reduced
automatically at high temperatures
Charger type Eight step, fully automatic charging cycle
Battery types All types of 12V lead–acid batteries (WET, MF, Ca/Ca,
AGM and GEL)
Battery capacity 1.2–110Ah up to 160Ah for maintenance
dimensions 168 x 65 x 38mm (L x W x H)
Insulation class IP65
Weight 0.6kg
*) Back current drain is the current that drains the battery if the charger is not connected to
the mains. CTEK chargers have a very low back current.
**) The quality of the charging voltage and charging current is very important. A high cur-
rent ripple heats up the battery which has an aging effect on the positive electrode. High
voltage ripple could harm other equipment that is connected to the battery. CTEK battery
chargers produce very clean voltage and current with low ripple.
+
+
–
–
MODE
RECOND BATTER Y STA RT POW ER ALTERN ATOR VOLTA GE CHE CK PR OGRAM MXS 5.0 CHECK BY
CONNECT ANd dISCONNECT THE CHARGER TO A BATTERY
Comfort
Connect
Comfort
Connect
INFO
If the battery clamps are incor-
rectly connected, the reverse
polarity protection will ensure that
the battery and charger are not
damaged.
For batteries mounted inside a
vehicle
1. Connect the red clamp to the bat-
tery's positive pole.
2. Connect the black clamp to the
vehicle chassis remote from the fuel
pipe and the battery.
3. Connect the charger to the wall
socket
4. Disconnect the charger from the wall
socket before disconnecting the battery
5. Disconnect the black clamp before
the red clamp.
Some vehicles may have posi-
tively earthed batteries.
1. Connect the black clamp to the bat-
tery's negative pole.
2. Connect the red clamp to the vehicle
chassis remote from the fuel pipe and
the battery.
3. Connect the charger to the wall
socket
4. Disconnect the charger from the wall
socket before disconnecting the battery
5. Disconnect the red clamp before the
black clamp.