CTI Products MCN Server 8000 - Manual (Page 212)

Appendix C: Installing Legacy PCLTA Interface Board & Driver
212 68-12286-110
Insert the PCLTA card into the slot, ensuring that the edge connectors are fully mated, and the slot
in the rear panel-mounting lug of the PCLTA is aligned with the threaded hole in the PC
chassis.
Replace the screw to hold the PCLTA firmly in place.
Reinsert the power cord and then restart the PC.
On power-up, Windows will automatically sense the Plug-n-Play adapter, and associate it with the
drivers installed in the previous step.
If the Plug ‘n Play features of the card failed, the following “Found New Hardware Wizard” window
may be displayed.
Select “No, not this time”, then click the Next button to display the following window.
On the above window, select “Install the software automatically”, and then click the Next button. Click
the Next or Finish buttons in the remaining windows to complete the installation.