CTI Products MCN Server 8000 - Manual (Page 61)

System Considerations
61 68-12286-110
•
For ASTRO® 25 7.13 systems, the PCs running MCN Server 8000 and ClientRCD software
may be installed only at the following locations:
Zone Core (Not on NM Subnet – no Multicast support)
K-Core
Collocated Vortex / NM Dispatch Site in Zore Core
Note: A Vortex /NM Dispatch Site may not be able to communicate with all the
comparators at other sites. Only Zone Core or K-Core or collocated Vortex / NM
Dispatch Site in Zore Core is available to see all the comparators.
•
For systems not running in an official MSI RNI, some of the above limitations may not apply,
but the non ASTRO®-specific considerations will apply.
Valid locations on the A7.13 RNI are shown below
Co-located Vortex
Site in Zone Core
Co-located NM Site in
Zone Core
IP Simulcast
Prime Site
Conventional
Hub
MCN
Server
8000
Yes Yes No Yes
CTI
Client
Yes Yes No Yes
HIB-IP No No Yes Yes
HIB-IP Considerations
•
Legacy HIB-IP modules (versions below 400) are not intended for operation across an Astro®
25 7x Radio Network Infrastructure (RNI).
•
HIB-IP 8000 modules (HIB-IP modules version 400 and up) support special UDP Ports
required to run across an Astro® 25 7.13 RNI.
•
For ASTRO® 25 7.13 systems, HIB-IP modules may be installed only in the following
locations:
Simulcast IP Prime Sites
Conventional Hub (C-Sub Hub) Sites
Default Software Settings
•
The defaults in the MCN Server 8000 and the MCN Client are configured to run in an
ASTRO® 25 7.12 system and higher.
•
The default UDP ports for the Server and Client are set according to Motorola's IP plan (per
specific ASTRO® 25 release).
•
The default Multicast IP address for the MCN Server 8000 software is configured for:
MCN Server #1 in Zone 1 at the Main Prime site.
If your system configuration is different, please refer to the Motorola IP Plan (per specific
ASTRO® 25 release) for the proper Multicast IP address.
Windows Accounts
In general, the programs should be run with the least privileges consistent with proper program
operation.. The programs need the following rights::