American Access Systems PhoneLink - Manual (Page 2)

Page 2 American Access Systems / Security Brands, Inc.
Contents
Two-Year Limited Warranty 3
FCC Requirements 3
DOC Requirements 4
Equipment Attachment Limitations 4
Parts Checklist 4
Tools Needed For Basic Installation 4
Technical/Customer Support 5
Introduction 5
Before Installation
5
Important Tips 5
Installation 6
Mounting the unit to an AAS Gooseneck Pedestal (18-001)
or double height Gooseneck (18-003) 6
Installation Steps 6
Wiring the Station 6
PhoneLink Circuit Board Layout 7
General Operating Instructions 9
Receiving Calls – Allowing Access 9
Call Waiting 9
Calling the Gate 9
Intercom (Audio) Mode 9
Indoor Command Code(s) Reference 9
Access and Function Codes 10
Good Tones and Error Tones 10
Resetting the Unit 10
Master Reset 10
Unit Reset 10
Idle Mode 11
The Program Mode 11
The * and # Keys 11
Programming the Gate 11
Sub-Mode 1 (Program Relay A Access Codes) 11
Sub-Mode 2 (Delete Codes) 11
Sub-Mode 3 (Change MASTER Code) 12
Sub-Mode 4 (Set Sleep Code & Latch Code and/or Call Forwarding) 12
Set Latch Code 12
(MASTER CODE) + 4 + 2 + LATCH CODE 12
Call Forwarding 12
Sub Mode 4 (Call Forwarding) 12
Sub-Mode 5 (Set One Shot Code) 13
Sub-Mode 6 (Set Relay Output Times) 13
Sub-Mode 7 (Program Relay B Access Codes) 13
Sub-Mode 8 (Enable/Disable 3 Strikes-You’re Out) 13
Sub-Mode 9 (Program Event Input) 13
Sub-Mode 0 (Erase all codes) 14
Troubleshooting 14
Customer Service and Tech Support
15