Asus Pedestal/5U Rackmount Server TS500-E4 Server - Manual (Page 64)

Chapter 2: Hardware setup 2-42
To reinstall a floppy disk drive:
1. Position the floppy drive vertically
with the eject button on the left
side (close to the HDDs).
2. Connect the drive signal cable and
power cable.
4. Secure the drive cage with a
screw.
3. Carefully push the drive into the
bay until the drive cage fits the
front edge of the bay.
Floppy drive power cable
Floppy drive signal cable
Red stripe to match Pin 1 on the connector