Impulse MAQ20-940 User Manual User Manual
Page 17
ReDAQ
®
Shape Software for MAQ
®
20 User Manual
17
Click on the [Save] button to save the changes. The system configuration is now stored in the
COM module nonvolatile memory and I/O modules will be shown in the same slots for all
subsequent power cycles.
Setup COM Tab:
Communication Parameters such as Slave ID, Serial Baud Rate, Parity, IP address and Subnet
mask are modified using this panel. Click on the [Save New Settings] button to store changes in
the COM module nonvolatile memory. Changes made to the communications settings do not
take effect until the system power has been removed and restored.
Real Time Clock: Click on the [Set RTC] button to edit the real time clock settings. Click on the
[Set RTC] button again to send the changes to the module.