Impulse MAQ20-940 User Manual - Manual (Page 54)

ReDAQ
®
Shape Software for MAQ
®
20 User Manual
54
24-hour day timer operation:
When the switch is turned on, the first event is executed, then the first 24-hour timer starts.
When the system time matches the programmed time, execution continues with the next
configured event and timer and this sequence will continue until all configured events are
finished.
Example 1:
A 24 Hour Day timer output starts at Event Off at 8:30:00 AM. At 9:00:00 AM it turns On. Next at
4:30:00 PM the timer output turns Off and at 5:00:00 PM it turns On. Finally, at 6:00:00 PM the
timer output turns Off and the process repeats.
Configure a discrete I/O channel to output and set the initial data to 0, or configure an analog
output channel with preset data of 0. Configure the timer as below:
Date/time timer operation:
When the switch is turned on the first Date / Time timer starts. When the system date and time
matches the programmed Date / Time the first event is executed then execution continues with
the next configured event and timer and this sequence will continue until all configured events are
finished. To terminate the timer, the last Event needs to be set to Stop.
Example 1:
A Date / Time timer output starts at Event Off at 8:30:00 AM, Sunday April 18, 2010. The timer
output turns On at 9:00:00 AM, Monday April 19, 2010, and then it turns Off.
Configure a discrete I/O channel to output and set the initial data to 0 or configure an analog
output channel with preset data of 0. Set the timer as below: