Impulse ACB-104.ULTRA (3514) - Manual (Page 7)

© Sealevel Systems, Inc. - 5 - ACB-104.ULTRA User Manual
Physical Installation
Extreme care should be taken when installing the adapter to avoid causing damage to
the connectors. After the adapter is installed, connect your I/O cable to P1. Please
note these connectors are keyed so that pin 1 of the cable matches pin 1 of the
connector. The ACB-104.ULTRA is a universal bus add-in board and can be used on
either 3V or 5V I/O signaling buses. Universal boards either use the VI/O signal to
determine its signaling level or are 3V signaling boards that have 5V-tolerant I/O.
Universal boards will work on either 3V or 5V I/O signaling buses. Manufacturers of
PC/104-Plus modules must clearly label near or on the PCI connector the module’s
PCI signaling capabilities. The ACB-104.ULTRA is clearly labeled ‘Universal’.
Do not install the Adapter in the machine until the software has been fully
installed.
1. Turn off power. Disconnect the power cord.
2. Remove the case cover (if applicable).
3. Gently insert the adapter noting proper key orientation of the expansion
connector on a PC/104 Plus expansion bus. The adapter is keyed per the current
PC/104 and PC/104-Plus Specification. This will aid in preventing the adapter
from being inserted incorrectly.
4. Mounting hardware (nylon stand-offs and screws) is provided to ensure a good
mechanical connection. Retain any mounting hardware not used to allow for
future expansion.
5. Replace the cover.
6. Connect the power cord and power up the machine.