Impulse 8004e - Manual (Page 11)

Hardware Installation
Do not install the PCI Express board until the software
has been successfully installed.
The DIO-32.PCIe does not need to be configured prior to installation.
Once you have installed the SeaI/O Classic software, install the board into an
available PCI Express slot and boot the computer. The Found New Hardware wizard
will appear. The drivers that were installed during the software installation process
will automatically be used to configure the adapter.
The following instructions are applicable to the Windows XP operating system and
may vary depending on your version of Windows.
1. After the software installation is complete, install the DIO-32.PCIe into an
available PCI Express slot and boot the computer.
2. A ‘Found New Hardware’ alert will appear above the system tray.
3. When the ‘Found New Hardware Wizard’ appears, choose ‘Install the
software automatically’ and click ‘Next’ (as shown in the image below).
© Sealevel Systems, Inc. - 9 - DIO-32.PCIe User Manual