Impulse 8126 - Manual (Page 30)

D/A Outputs Tab
The “D/A Outputs” tab is useful for manually setting the digital to analog output
voltages on applicable Sealevel I/O devices with D/A channels. A preliminary
diagnostics utility (see following page) has been provided to verify proper hardware
functionality.
The D/A outputs of the SeaI/O-470 and SeaDAC 8227 are factory set for 0-10V. To
configure the D/A outputs for 0-5V, you will need to open the enclosure and set the
correct jumpers. Refer to the Hardware Configuration section of this manual for
instructions on opening the enclosure and accessing the correct jumpers.
To adjust a particular channel’s output voltage, drag the slider until the desired
voltage is displayed in the window on the right side. Also, you may type the desired
voltage directly into the voltage display and then confirm your entry by pressing the
‘Enter’ key on your keyboard.
NOTE: The output voltage will not change until the ‘Enter’ key is pressed
or you have clicked on the window anywhere outside of the text
entry field.
© Sealevel Systems, Inc. - 28 - SeaDAC Lite User Manual