Impulse 2108 - Manual (Page 6)

© Sealevel Systems, Inc. - 4 - SeaLINK+232.PC User Manual
Physical Installation
The SeaLINK+232.PC can be installed in any spare bracket location.
Do not install the Adapter in the machine until the software has been fully
installed.
The SeaLINK+232.PC can be connected to any header type USB connector that
supports the Intel assigned connector pinout. The SeaLINK+232.PC will require no
user hardware configuration. Once you have installed the software simply plug the
SeaLINK+232.PC into an available USB connector on the motherboard. The drivers
that were installed during setup will automatically be used to configure the adapter.
You should see one or more “New Hardware Found”, indicating the actual port being
created. If you view your systems’ Device Manager at this point, you should have a
new “COM” port in the Ports (COM & LPT) Device Class. You can access your new
COM: port by using the assigned COM: identifier. This assignment will vary from
system to system. At this point, the hardware is recognized. To verify operation use
Sealevel Systems supplied WinSSD diagnostic utility. WinSSD can be found in the
Start, Programs group.