Laurel Electronics LT SERIES TRANSMITTERS ANALOG INPUT User Manual
Page 8
- 8 -
7. PROGRAMMING YOUR TRANSMITTER
OVERVIEW
Our transmitters are easily programmed using a PC with an RS232 port and Instrument Setup
(IS) software, which provides a graphical user interface. The software allows uploading, editing,
downloading and saving of setup data, execution of commands under computer control, listing,
plotting and graphing of data, and computer prompted calibration.
USING IS SOFTWARE
Use a 3-wire RS232 cable (P/N CBL04) to connect your transmitter to the COM port of your PC.
Download the file
ISx_x_x.exe
from our website and double-click on the file name. Click on
Install Instrument Setup Software
and follow the prompts. To launch IS software, press on
Start => Programs => IS2 => Instrument Setup
or on the desktop icon that you may have
created. Following a brief splash screen, the
Communications Setup
screen will appear.
RS232 cable with rear view of DB9
connector to PC
In the Communications Setup screen, select the
Custom ASCII
as the protocol, as this is the
factory default setting. Select
Transmitter LTA
as the Device Type. Then click on the
RS-232
(USB)
button. This will take you to the
Establish Communications
screen.