Lectrosonics UH110 - Manual (Page 8)

SPECIFICATIONS AND FEATURES
Operating frequencies:
Frequency selection:
RF Power output:
Frequency stability:
Deviation:
Spurious radiation:
Equivalent input noise:
Input level:
Input impedance:
Input compressor:
Gain control range:
Modulation indicators:
Controls:
Audio Input Jack:
Battery:
Battery Life:
Weight:
Dimensions:
Emission Designator:
537.6 to 862.0 MHz
256 frequencies in 100kHz steps (25kHz programmable)
50 mW (nominal)
± 0.001%
± 20 kHz typ, ± 50kHz max
90 dB below carrier at frequencies less than 1GHz
-126 dBV
Nominal 2 mV to 300 mV, before limiting.
Input greater than 2V, with limiting.
1K Ohm mic load impedance
Soft compressor, >30 dB range
43 dB; semi-log rotary control
Dual LEDs indicate modulation level 12 dB below limiting and at
the onset of limiting.
2-position “OFF-ON” slide switch. Control panel knob adjusts audio
gain. Rotary switches on side panel adjust transmitter frequency.
3-Pin XLR
Precision compartment auto-adjusts to accept any known alkaline
or lithium 9 Volt battery. (We’ve tried 150 different ones!)
7 Hours with alkaline 9 Volt, 14 hrs with lithium
6.6 ozs. including battery
3.1 x 2.4 x .75 inches
180KF3E
Specifications subject to change without notice.
8