Lectrosonics HBATELIM - Manual (Page 2)

BELT-PACK
TRANSMITTER
INSTRUCTIONS
Figure B
Figure A
Remove the four screws noted in Figure A and
lift bezel from control panel.
Remove battery door and place modified battery
door in exactly the same position. Make sure
modified battery door is oriented the same way
as standard door.
Place the bezel on top of the modified door and
carefully tighten the four screws.
Insert the HBATELIM. The unit should look like
Figure B.
Fold the door cover down so it is flush with the
bezel and snap into place by pushing toward the
level control.
PLUG-ON
TRANSMITTER
INSTRUCTIONS
Caution:
When removing a standard door to replace
with a modified door, proceed carefully as
the metal spring and tabs can easily be bent
with too much force.
Figure C
Remove rear screw on bottom of case.
Figure D
Note: Frequency agile models have sliding door
and bezel on this side, however, screw is in the
same location.