Lectrosonics HBATELIM - Manual (Page 3)

Open battery door and loosen screw that
holds the spring to the case bottom.
Loosen the screw several turns but do
not remove it.
Figure E
bezel
Figure F
Place unit in an upright position while
holding the bezel slightly away from the
casing. Grip door with thumb and forefin­
ger and gently lift it out of the bezel. If the
door does not lift out easily, pry the bezel
up slightly with your fingernail. The door
should now slide out.
metal
tabs
on spring
Grip modified door (has hole in it) with thumb and
forefinger and gently slide door hinge into place.
Be careful not to bend the spring or force the
hinge. Make sure the hinge of the modified door
fits behind the two little metal tabs (see inset
above). It will fit into place without much effort.
Re-align all parts before tightening screws.
Tighten screw holding spring to the case bottom
that was loosened in Figure E.
Replace and tighten screw on bottom of case that
was removed in Figure C.
Figure H
Install dummy battery as shown so that the con­
nector aligns with the access hole in the door.
Polarity is different on different models—connec­
tor will align with access hole in either orientation.
Figure G