Lectrosonics DNTBOB 88 - Manual (Page 14)

ASPEN Digital Processor
LECTROSONICS, INC. 14
Specifications
Analog inputs:
Type Floating balanced
Level 0 dBu; 20 dB headroom
Impedance 15k ohm (differential); 3.75k ohm (common)
Connector 5-pin Phoenix
Analog outputs:
Type Floating balanced
Level 0 dBu; 20 dB headroom
Impedance 50 ohms
Connector 5-pin Phoenix
Sampling Rate: 48 kHz
Network Interface: Dante
Latency:
Analog in to Dante network: 0.721 ms
Dante network to analog out: Network latency + 0.521 ms
THD + Noise: 0.02%; analog in to analog out
Audio Frequency Response: 20Hz to 20kHz; ±0.1 dB
Input to Output Gain: 0 dB; ±1 dB
Ambient Operating Temperature: –20 C to +50 C; –36 F to +90 F
Power Requirements: 15 VDC; 800 mA
Power Consumption: 12 Watts
Dimensions (overall): 1.73 x 13.36 x 4.6 in.
44 x 339 x 117 mm.
Weight: 22.3 ozs.; 631 grams
FCC Part 15 Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired op-
eration.
CAUTION: Changes or modifications not expressly
approved by Lectrosonics, Inc. could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. The
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment
and receiver
• Connect the equipment into an outlet on a circuit
different from that which the receiver is connected
• Consult the dealer or an experienced radio/TV
technician for help
Changes or modifications to this equipment not ex-
pressly approved by Lectrosonics, Inc. could void the
user’s authority to operate it.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme a
la norme NMB-003 du Canada.