Lectrosonics SPN32i - Manual (Page 12)

ASPEN Input Only Processors
LECTROSONICS, INC. 12
After selecting the mode and/or changing the passcode,
select SAVE with the rotary control and press the center
switch to save the settings.
A progress bar
will appear as the
settings are saved.
Press the LEFT (9:00 o’clock) button to return to the
previous screen.
Master Reset
Hold the LEFT and UP buttons in at power up to restore
factory default settings.
WARNING: Master Reset will remove all stored
settings, unlock the control panel and reset the
passcode to five center button presses.
Master Reset takes about 75 seconds to complete
while the center (white) LED on the front panel stays lit.
The display will then return to the Main Window and the
right (blue) LED will light up to indicate power ON and a
“ready” status.
Initial Setup
The processor requires a minimum setup before it will
pass signals:
• Input Gain Value
• Crosspoint Gain Value
• Output Gain Value
These three minimum settings can be made with the
LCD or software GUI.
Input Setup
Select [INP] on the Main Window.
Select Mic/Line Input Setup (Input Levels is a dymanic
display that shows bar graphs of activity).
Navigate to each cell and enter a value. For micro-
phones, 40 to 50 dB is a normal value. For line levels,
0 dB is a commonly used value. If phantom power is
needed, be sure to check the 48V cell for each micro-
phone using the rotary control.
Matrix Crosspoint Setup
Select [MAT] on the Main Window.
Scroll to the desired Crosspoint setting and select it.
The UP and DOWN buttons can also be used to scroll
the menu items.