Lectrosonics SPN32i - Manual (Page 18)

ASPEN Input Only Processors
LECTROSONICS, INC. 18
Using the Software GUI
for Minimum Setup
An Input, crosspoint and output must be defined to cre-
ate a path that allows the processor to pass a signal.
This required minimum setup can be accomplished
quickly using the sofware GUI.
Launch the ASPEN Control Panel. The first screen is
blank with tabs at the top of the window to select the
desired action.
Select the
Connect tab and then click on the method of
communication; in this example, USB.
This popup will
appear with
the Master unit
displayed
A popup window will appear with a list of processors
that are connected. Click on a unit inside the popup
window to add it to the control panel list.
Click on the desired unit
in the control panel list.
Click on the desired unit in the list to open a control
panel for that processor. The panel opens to the Activ-
ity window, which is a real time level display.
Define inputs, crosspoints and outputs on the appropri-
ate tabs for a required minimum setup.
NOTE: Matrix crosspoints must be assigned in
the Input Only processor and output sources must
be assigned to these crosspoints in a Mixer or
Conference processor to allow the signals to be
delivered to the system outputs.
Click to
scroll
tabs
The Device Settings tab opens access to several setup
screens such as Preset Management.
Device Settings tab
Category bar for access to
setup screens