Lectrosonics SPN32i - Manual (Page 4)

ASPEN Input Only Processors
LECTROSONICS, INC. 4
Inspection of the Unit
Compare the packing list enclosed with the unit with the
original order. Inspect all items for damage. Immediately
call 1-800-821-1121 to report any items that are miss-
ing or damaged. The sooner you notify us, the sooner
you will get any needed replacement items shipped to
your location.
Table of Contents
Important Safety Instructions............................................. 3
Inspection of the Unit .......................................................... 4
Introduction .......................................................................... 5
Quick Start Essential Settings ........................................... 5
Front Panel ........................................................................... 6
Rear Panel ............................................................................ 7
Hardware Installation .......................................................... 8
Installing the chassis into a rack ........................................ 8
Cables ............................................................................... 8
Audio Connectors ............................................................. 8
Audio Inputs-Unbalanced ................................................... 8
Programmable Inputs ......................................................... 9
Programmable Outputs ...................................................... 9
ASPEN RS-232 Port (PC Connection) ............................ 10
Cabling of Stacked Units .................................................. 10
Using the LCD .................................................................... 11
Stacking Multiple Units ..................................................... 14
Software and Firmware Updates ...................................... 14
Creating an ASPEN Installer Disk .................................... 15
Firmware Update Procedure ............................................. 15
Software Installation ......................................................... 16
USB Driver Installation ...................................................... 17
Using the Software GUIfor Minimum Setup .................... 21
FCC Part 15 Compliance ................................................... 22
Service and Repair ............................................................ 23
Returning Units for Repair ............................................... 23
FCC Part 15 Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired opera-
tion.
CAUTION: Changes or modifications not expressly
approved by Lectrosonics, Inc. could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user
will be required to correct the interference at his own
expense.