Level Mount ELEW7-07 - Manual

DELUXE 10’ CORD MANAGEMENT
SYSTEM (EZEW7-01)
The EasyMount Cord Management System
is the simple solution for concealing and
grouping the variety of cords attached to your
television monitor.
BEFORE YOU BEGIN
Caution: To prevent damage to the Cord
Management System or to the equipment
that is attached to it, please follow the instruc-
tions carefully.
When painting the Cord Management System,
please paint and allow to completely dry
BEFORE installation on a wall. This will allow
for the most professional result without drips
and runs.
** It is recommended to get a person to
dismount and hold the television while
fastening the pan screws into the wall
TOOLS REQUIRED FOR INSTALLATION
Phillips screwdriver
STEP 1:
Before you begin installing the Cord
Management System, you must determine
which piece is best to attach.
If you have an EasyMount Fixed Wall Mount
(EZFW) or any other similar mount then use the
4” Flat Cord Cover to begin installation.
If you have an EasyMount Swivel/Tilt (EZSJ),
Swivel/Tilt/Extended Mount (EZDJ) or any
other similar mount then use the 4” Rounded
Cover to begin installation.
STEP 2:
After determining which section fits your needs,
place the cord cover over your cord(s) and use
a Phillips screwdriver to fasten the 4 pan screws
into the initial first section. Make sure that the
cord cover is in a perfectly vertical position
prior to attaching the pan screws. We recom-
mend using a level, or measuring 2 points
equal distance from the corner of the room.
This will allow the cord cover to be straight
when all segments are attached. You may want
to use the nail included in the kit to begin a
basic hole before fastening the Pan Screws. Do
not over tighten the screws.
STEP 3:
Next, determine which piece will best fit your
needs. To attach a Cord Management section,
slide the lip of a Cord Management piece
inside of the initial 4” Flat or 4” Rounded
section (Diagram 1). Utilize a nail to start the
hole allowing you to more easily fasten the
2 pan screws into the bottom of the Cord
Management section (Diagram 2). After the
screws are fastened, attach another Cord
Management section and repeat until cords
are covered. Do not over tighten screws.
Installation instructions UK
(12) 8’’ Straight
Section
(44x) 3⁄4’’ Pan
Screws
(1x) 4’’ Rounded
Section
(1x) 4’’ Flat
Section
Side View
2005 Market Link USA, Inc., All rights reserved. EasyMount, the EasyMount design,
and other related logos are trademarks of Market Link USA, Inc.
Diagram 1 Diagram 2
KIT INCLUDES
(1x) Nail (1x) 6’’ Outside
Corner
(1x) 6’’ Inside
Corner
(1x) 6’’ Right
Corner
(1x) 6’’ Left
Corner
3⁄4’’ Pan
Screws
4” Round
Section
4” Flat
Section
OR
www.EasyMount.net
1-888-229-1459
©2005 EasyMount
Patents Pending
Wall
4” Cord Cover
Lip
Additional Section