Magnum Venus Plastech PATRIOT 1:1 ADHESIVE SYSTEM - Manual (Page 21)

Patriot 1:1 Adhesive System Operations Manual
Rev. 09/2012 Page | 21
Priming the Adhesive and Activator:
1. Fill the Adhesive pump and Activator pump solvent cups with throat seal liquid (see figure 10).
Figure 10
2. Move the ram up/down valve handle to the up position (see figure 11).
Figure 11
NOTE:
Do not install static mixer tube to gun at this time.
3.
To raise the Pump Ram, slowly increase air pressure on the regulator (marked air lift) to 15 to 20
psi (see figure 11).
4.
While the barrel piston is going up, check that hoses are moving freely and no hoses are kinking.
5.
Slide 5-gallon (20 liter) pails of material onto the unit and position to the barrel pistons.
6.
Open the air bleed ball valve located at the top of the barrel piston; this will allow air trapped
between the barrel piston and the material to escape. (see fig. 12)
Figure 12
Air Bleed Valves
Ram UP/DOWN Valve