Magnum Venus Plastech Pro Gun CPD_PRTM - 1:1 - Manual (Page 22)

1:1 Classic Pro Gun Manual
Rev. 05/2012 Page | 22
Remove Mix Housing
1. Remove the Nozzle cap or Mixer assembly from the Mix housing.
2.
Use the turbulent mixer puller to remove the turbulent mixer by inserting the
puller and giving a slight twist.
(if applicable to this unit)
3. Remove the Plugs (58696-1) and Seals (58695-1) from the Mix housing.
4. Remove the Springs (04319) and Balls (03199) from the Mix housing.
5. Remove the Plugs (7102-5-6) and Seals (02441-1) on the side of the mix chamber.
6. Remove the four Screws (02959-5) from the Mix housing (58692-3) and remove
the Mix housing (58692-3) from the gun block.
7. Remove the Face Seals (58694-1)
8. Inspect and clean the Mix housing
NOTE: Putty systems using BPO do not use 04319 (spring) and 03199 (ball) on
the putty side of the gun block.
Remove Hose Fittings
1. Remove and clean the Hose fitting and O-ring on the rear of the gun block. See
“Gun Fitting” document in the back of this manual for fitting numbers.
Remove Valve Rod
1. Remove the Actuating stem (5104-11-1) from the Valve rod (58693-1), if this has
not already been done.
2. Remove the two Packing nuts (5104-8-1) located on each side of the gun block.
Clean the packing nut threads.
ACTUATOR STEM