Luminex xPONENT 3.1 Rev 2 (IVD) - Manual (Page 55)

• Auto Maint
• Lot Management
• Cmds & Routines
• Probe & Heater
• System Info
• System Status
• Schedule
• Support Utility
Auto Maint Tab
This tab contains routines to initialize, verify, and maintain the analyzer.
FIGURE 30. Auto Maint Tab
Automated Maintenance Options - Provides buttons for commonly used maintenance
routines for the machine. Select from the following:
• System Initialization - Select this routine to initialize the system.
• Performance Verification - Select this routine to use with the Performance Verification kit.
• Calibration / Verification - Select this routine to use with the Calibration/Verification kit.
• System Shutdown - Select this routine to perform a pre-defined system shutdown.
• Alcohol Flush - Select this routine to run a single alcohol flush.
• Sanitize - Select this routine to run a sanitize command.
For In Vitro Diagnostic Use Touring the Software
45