AT&T 1175 - Manual (Page 5)

7
Getting Started
6
Getting Started
Battery installation & charging
After installation, place the handset in the base and allow the battery to charge for 12
hours before use. You can keep the battery charged by returning the handset to the base
after each use. When battery power is fully depleted, a full recharge takes about 8 hours.
Press tab to open
battery compartment
Plug in battery here
Insert battery and
replace compartment
cover
Place handset in base to charge
for 12 hours before first use.
Charging light will be illuminated
while battery is charging.
Telephone base installation
Install the speakerphone base as shown below. Choose a location away from electron-
ic equipment, such as personal computers, television sets or microwave ovens. Avoid
excessive heat, cold, dust or moisture.
Plug power cord
transformer into
electrical outlet
Plug long line cord
into telephone jack
Low battery indicator
Return handset to base to recharge
when this symbol appears. (Handset
will beep when battery is low.)
NOTE: Use only the power
cord supplied with this product.
If you need a replacement,call
1 800 222–3111.
Be sure to use an electrical outlet
not controlled by a wall switch.
Rotate antenna
to fully upright
position
NEW 00 OLD 27
0 8/12 10:06 AM