AT&T 1175 - Manual (Page 9)

15 14
Telephone Operation
Directory Dialing
Directory dialing (handset)
The telephone directory in the handset can store up to
50 names and telephone numbers. Each entry can con-
tain a number up to 24 digits, and a name up to 15 let-
ters long. A convenient search feature can help you find
and dial numbers quickly (see pages 16-19).
Speed dialing (base)
In addition to the phone directory, you can add up to 10
numbers you dial frequently into the Speed Dial memo-
ry in the base. These numbers can be dialed with three
button presses (see next page).
Error tones
Base: If you pause for too long while entering a Speed
Dial number an error tone may sound and you will have
to begin again.
Handset: If all memory locations are in use, an error
tone will sound when you press
@
PROG
and @
SEL
to enter a number. This means the memory is full, and
you will not be able to store a new number until you
delete an existing one.
Handset:
50 Directory numbers
Speakerphone Base:
10 Speed Dial numbers
Handset locator & intercom
Handset locator
If the handset is misplaced, press
@
HANDSET
LOCATOR
on the base. The handset will beep for 60
seconds to help you find it. When the handset is found,
press
O to stop the beeping (or press @
HANDSET
LOCATOR
on the base).
Intercom calls
The intercom feature allows conversation between the
handset and base.
You can press
@
INTERCOM
at the handset or the
base to initiate an intercom call. If the call is initiated at
the handset, the base will answer immediately. If the call
is intiated at the base, you must press
@
INTERCOM
at
the handset to answer and begin talking.
When your intercom call is finished, press
O at the
handset (or @
INTERCOM
at the base) to end the call.
If the phone rings during an intercom call, press P at
the handset (or @
SPEAKER
at the base) to terminate
the intercom conversation and answer the incoming call.
Hold paging (for 3-way conference calls)
During a speakerphone conversation, press
@
HOLD
at
the base to place your call on hold, then press
@
INTERCOM
to page someone else at the handset.
The other person can then press P and begin speaking
to the caller. Press @
SPEAKER
at the base to rejoin
the call for three-way conversation.