MAX RB217 - Manual (Page 24)

24
4. Tension adjustment
1 Be sure to turn the Main switch OFF, to lock
the Trigger and detach the Battery pack.
2 This dial allows you to adjust wire tension
torque slightly.
To increase the tension, turn it in the coun-
terclockwise.
To decrease the tension, turn it in the clock-
wise.
3 Insert the charged battery pack into the tool
until a click is heard.
• When setting the main switch to ON, abso-
lutely do not bring your hand close to the
binding part or rotating part of the tip of the
tool.
4 Set the Trigger Lock to UNLOCK and turn on
the main switch.
5 Test the tool again to check the tie strength.
6 If the tie strength is not appropriate, repeat
procedures 1~5.
RB397
OFF
Torque dial
WARNING
Appropriate
Reinforcing bars Over-tightened