MAX RB217 - Manual (Page 9)

9
12 Avoid continual use of the Battery
charger
Rest the Charger for 15 minutes between
charges to avoid functional trouble with
the unit.
13 Any objects that block the ventilation
holes or Battery pack receptacle may
cause electric shock or functional
troubles
Operate the charger free of dust or other
foreign materials.
14 Handle the power cord carefully
Do not carry the Battery charger by its
power cord. Do not use the power cord to
disconnect it from a wall socket; this will
damage the cord and break the wires or
cause a short circuit. Do not let the power
cord contact sharp edged tools, hot mate-
rials, oil, or grease. A damaged cord must
be repaired or replaced.
15 Do not charge non rechargeable bat-
teries with this charger.
16 This charger is not intended for use by
children or disabled persons without
supervisor.
17 Children should be supervised to en-
sure that they do not play with the
charger.
18 Put a pack cap on the terminal of the
Battery pack
When the Battery pack is not in use, put a
pack cap on its terminal to prevent short
circuits.
19 Do not let the terminal (metal compo-
nent) of the Battery pack short-circuit
A short circuit in the terminal will generate
a large current, causing to overheat the
Battery pack and become damaged.
20 Do not leave or store the tool in a vehi-
cle or in direct sunlight during sum-
mer. Leaving the tool in high
temperature conditions may cause the
battery pack to deteriorate.
21 Do not store a fully discharged battery
pack. If a fully discharged battery pack
is removed from the system and left for
a long period of time, it may become
damaged. Recharge the battery imme-
diately when it has been discharged.
14. WEAR SAFETY GLOVES WHILE OPER-
ATING THE TOOL
The finish tie has sharp edges. To avoid seri-
ous injures, be careful not to touch the sharp
edges. MAX recommends wearing safety
gloves while operating the tool.