MAX LM-380A - Manual (Page 56)

PRINTING
56
7. PRINTING
Printing the created document.
7-1 PRINT RANGE SETTING SCREEN
You can print desired blocks by inputting block No.
1. Press PRINT . [PRINTING RANGE setting screen]
appears.
(The function of “COPIES”)
LM-380A print the created document according to the number of “COPIES”
If “2” is inputted in “COPIES”, LM-380A prints the same document twice automatically.
2. Press / key or Ten key to input the desired No. as the “COPIES “, “START NO” and the “END
NO.”
3. Press ENTER after inputting the “END NO” And then [PRINTING LENGTH ALIGHNMENT
screen] appears.
7-2 PRINTING LENGTH ALIGHNMENT
Adjusting the total printing length.
You can adjust the total printing length of tubes or tapes, if the actual printed length is
different from the displayed length..
1. [PRINTING LENGTH ALIGHNMENT screen] appears.
The upper field automatically displays the total calculated
length to be printed.
The lower field displays the value to adjust.
2. Press / key to the value incrementally or detrimentally.
If +8mm is inputted as the value, 8mm is added to the actual
printed result.
3. Press ENTER to start to print.
Setting value: COPIES: 1
v v v v
10
START NO. = 1
END NO. = The last block No. of the
created document.
Setting range: -30 to +30mm
Default value: 0mm
F€"‚ (U07I F€"‚ (U07I F€"‚ (U07I F€"‚ (U07I
Pb € (e2b† Pb € (e2b† Pb € (e2b† Pb € (e2b† 3 3 3 3
9© ‚  9© ‚  9© ‚  9© ‚  0#† 0#† 0#† 0#† 3 3 3 3
2b0 2b0 2b0 2b0 0#† 0#† 0#† 0#†
F€"‚ (U0 F€"‚ (U0 F€"‚ (U0 F€"‚ (U0 'b2b0"”–7I 'b2b0"”–7I 'b2b0"”–7I 'b2b0"”–7I
!  !  !  ! $# # # #“   —DD DD DD DD
©)')(ƒ”0 G 2b0—† ©)')(ƒ”0 G 2b0—† ©)')(ƒ”0 G 2b0—† ©)')(ƒ”0 G 2b0—†
    DD DD DD DD
F€"‚ (U0 F€"‚ (U0 F€"‚ (U0 F€"‚ (U0 'b2b0"”–7I 'b2b0"”–7I 'b2b0"”–7I 'b2b0"”–7I
!  !  !  ! $# # # #“   —DD DD DD DD
©)')(ƒ”0 G 2b0—† ©)')(ƒ”0 G 2b0—† ©)')(ƒ”0 G 2b0—† ©)')(ƒ”0 G 2b0—†
% % % % DD DD DD DD