Nilfisk-ALTO PHH15002A - Manual

Dear Owner,
Congratulations! Thank you for purchasing this new heater manufactured by a division of Marley
Engineered Products. You have made a wise investment selecting the highest quality product in the heat-
ing industry. Please carefully read and follow the installation and maintenance directions shown in this
manual. You should enjoy years of efficient heating comfort with this product from Marley Engineered
Products... the industry’s leader in design, manufacturing, quality and service.
... The Employees of
Marley Engineered Products
Read Carefully - This instruction sheet contains vital informa-
tion for the installation, use and efficient operation of the heater.
Carefully read the manual before installation, operation, or cleaning
of the heater. Failure to adhere to the instructions could result in
fire, electric shock, death, serious personal injury, or property dam-
age. Save these instructions and review frequently for continuing
safe operation and instructing future users.
1.
Do Not operate heater without both support leg extensions
properly installed.(See Fig. 1) Do not allow heater to operate
in any position except as shown in this manual.
2. Do Not install heater against combustible low-density cellulose
fiberboard surfaces.
3. Heater is not to be located below an electical convenience
outlet.
4. When moving, allow heater to cool then grasp heater along the
top of the back of the heater.
5. This heater is to be used on the floor only. Do not use on shelf,
table, bed, or any location except the floor.
6. This heater is a major electrical appliance and requires
adequate electrical power for safe use. The outlet to which the
heater is connected must be a 120 volt , AC circuit protected by a 15
or 20 amp fuse or circuit breaker in accordance with the
National and Local Electric Codes. No other major electrical
appliance can be operated on the same circuit as the heater.
7. To prevent electric shock match wide blade of plug to wide
slot in outlet and insert fully.
8. Plug heater power cord directly into the electrical outlet.
Never use an extension cord with this heater.
9. Heater surfaces may reach high temperatures during use.
Keep all electrical cords, drapes, bedding materials, and
other furnishings away from heater. Never place anything on
top of heater. It is recommended that a space of at least
twelve (12) inches be maintained around heater.
10. Do Not store or use gasoline or other liquids with flammable
vapors in the vicinity of this heater.
11. Do Not use this heater near water (as in a wet basement or near
swimming pools) or in a very humid environment.
12. When heater is not to be used for an extended time, turn off
heater by rotating thermostat knob to “OFF” position and
unplug heater. Wrap power cord to prevent damage and
move heater to safe place for storage.
13. Keep this heater clean. Do not allow dirt or dust to accumulate
around element fins or the outlet grille area. See Cleaning
Instructions section of this manual.
14. If this heater or its power cord becomes damaged or malfunc-
tions in any way, unplug heater, discontinue use, and have unit
repaired by a reputable repair service.
WARNING
OWNER’S MANUAL
FILE #E37116
The Choice of Professionals
P O R TA B L E E L E C T R I C
H Y D R O N I C B A S E B O A R D
H E AT E R
MODEL
NO.
VOLTS WATTS AMPS
1500/750
BTU/HR
PHH15002A 120V 12.5/6.3 5120/2560
!
SAVE THESE INSTRUCTIONS