Micromod MOD: Extended Modbus (XModbus) OPC Server Users Guide - Manual (Page 18)

Extended Modbus OPC Server
Application Tutorial
Figure 3 .3.
Port Properties
• Select the COMM port from the drop-down menu in the Port field and then enable
it by checking the box next to the Enable field.
• Choose the Baud Rate, Parity, Flow Control, Data bits and Stop bits from this
dialog box. Make sure these entries match the settings of the instrument.
• Click on OK to complete the Port configuration.
• The Extended Modbus Device Properties dialog box will redisplay with the port
number. Leave other fields on this dialog box at their default values.
• Click on OK. The added device will be displayed in the Device Tree on the left
frame as shown in the next figure:
Figure 3 .4.
ABB Extended
Modbus OPC
Server database
4. Save the database: The OPC tag database can be save as a file with an extension
.MOPC.
• Select File – Save from the menu bar. Refer to the following figure.
• The Save As dialog box will be displayed next as shown below:
• Choose the same folder where you have saved the PIDLAB database for saving
this file and then type a name for the OPC tag database file in the File name field.
3 - 4