Alliance Laundry Systems CHM160C - Manual (Page 13)

Operation
11 F232172 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Display Indicators
Table 1 lists the various displays and what they mean.
The operator should become familiar with these
machine displays.
Display Meaning
tESt Diagnostic test cycle selected or enabled
SPIn Spin (extract) step
SUP1 Supply signal 1 (“S1” output), normally detergent
SUP2 Supply signal 2 (“S2” output), normally bleach
SUP3 Supply signal 3 (“S3” output), normally softener
SdLY Spin coast (motor coasts after high speed extract)
CFIL Cold Fill
HFIL Hot Fill
bFIL Warm Fill (cold + hot)
bLCH Control will also light “add bleach” indicator
PASS Variable-speed ONLY – balance “PASS” condition; shows in “test” cycle only
FAIL Variable-speed ONLY – balance “FAIL” condition; shows in “test” cycle only
bAL? Variable-speed ONLY – meaning: “Do you wish to enter balance detection test routine?”
CY__ Cycle number (followed by a space and number 1 through highest cycle number)
nor
n Normal agitation selected
gEnt Gentle (reduced) agitation selected
For Wash speed forward (during test cycle)
rEv Wash speed reverse (during test cycle)
dISt Variable-speed ONLY – distribution speed (during test cycle)
LO Low water level
n
Ed Medium water level
HI High water level; also denotes “HIGH” spin speed in variable speed “test” cycle.
CEL Display all temperatures in degrees Celsius
FAr Display all temperatures in degrees Fahrenheit
___C The first 3 digits are reserved for temperature reading, C indicates “degrees Celsius”
___F The first 3 digits are reserved for temperature reading, F indicates “degrees Fahrenheit”
FILL
“Fill error” – machine did not fill to programmed water level within 10 minutes; also shows
during Rapid Advance mode, refer to Programming Manual
door “Door” opened during cycle
SHUt / door Machine user must “shut door” of the washer to allow the cycle to begin
Table 1 (Continued)